F510 & F525 Blade Drive Belt – REMOVE AND INSTALL BELT

1. Park mower on hard, level surface.
2. Crank mower to highest position.
3. Remove two pins (A) holding cable end.

4. Crank mower all the way down.
5. Pivot handle (A) to the left to release belt tension.
6. Remove spring from handle.
7. Reach under frame behind drive wheel to remove belt
from engine sheave.

8. Remove ring pins from push arms:
• Lift end of ring pin (A) to remove it.
• Remove drilled pin.

9. Remove spring pin (A) and long pin.
10. Remove center arm bushing (B) from push arm.

11. Use straps (A) or ropes to hold push arms up.
12. Pull mower away from Front Mower.

13. Remove spring locking pin and drilled pin (A) holding center arm to yoke.
14. Pivot mower center arm all the way forward.

15. Remove belt shields:
• F510 Mower: Remove six screws (A).
• F525 Mower: Loosen six screws.

F525 Mower NOTE: Steps 16—20 are for mowers (S.N. —130000) only. See Steps 21—24 for mowers (S.N. 130001—
) or for early mowers that have been updated.
16. Remove belts.
17. Install short belt first, then install long belt as shown.
18. F510 Mower: Tape belt in two places (A) to keep belt in place while installing shield.
19. Install and fasten belt shields:
• F510: Install and tighten six screws.
• F525: Tighten six screws.
20. Fasten center arm to yoke at rear of mower.

21. Remove belts. Install long belt as shown.
22. F510 Mower: Tape belt in two places (A) to keep belt in place while installing shield.
23. Install and fasten belt shields:
• F510: Install and tighten six screws.
• F525: Tighten six screws.
24. Fasten center arm to yoke at rear of mower.

24. August 2021 by samuel07042012
Categories: F510-F525 | Leave a comment

Leave a Reply

Required fields are marked *