F510 & F525 Cylinder Block – INSPECT AND REPLACE GOVERNOR ARM

NOTE: It is not necessary to remove governor shaft unless damaged.
1. Remove crankcase cover. (See Remove and Install Crankcase Cover in this group.)
2. Inspect arm (A). Replace if damaged.
3. To replace shaft, loosen nut (B) on lever (C).
4. Remove retaining pin (D), governor shaft and washer (E).
5. Install washer, shaft and retaining pin. Tighten nut to
7 N·m (62 lb-in.).

07. June 2021 by samuel07042012
Categories: F510-F525 | Leave a comment

Leave a Reply

Required fields are marked *