F510 & F525 Transmission – INSPECT AXLE ASSEMBLY

1. Clean ball bearing with solvent and dry with compressed air, while keeping the bearing from spinning.
2. Check ball bearing for axial (A) and radial (B) free play. Rotate bearing slowly. Replace if free play is excessive or bearing does not operate smoothly.

3. Check axle run-out using V-blocks and dial indicator.
Replace axle if not within specifications.
4. Measure outside diameter of journals (A) and (C).
Replace axle if not within specifications.
5. Inspect journal (B) and spline (D) for nicks, scoring or
damage. Blend spline nicks using fine grade oil stone.
Replace axle if necessary.

23. June 2021 by samuel07042012
Categories: F510-F525 | Leave a comment

Leave a Reply

Required fields are marked *