F510 & F525 Cylinder Block – INSPECT CONNECTING ROD

1. Clean and inspect rod. Replace if scored.
2. Analyze crankshaft and connecting rod wear. (See Analyze Crankshaft and Connecting Rod Wear in this group.)
3. Install connecting rod cap. Apply a light film of oil to connecting rod cap screws. Tighten to 20 N·m (177lb-in.).
4. Measure connecting rod crankshaft bearing and piston bearing (A). Replace connecting rod if either measurement is greater than specifications.

06. June 2021 by samuel07042012
Categories: F510-F525 | Leave a comment

Leave a Reply

Required fields are marked *