F510 & F525 Transmission – REMOVE AND INSTALL AXLE ASSEMBLIES

NOTE: Axle assemblies can be removed without disassembling transaxle.
1. Remove snap ring (A).
2. Install puller in threaded axle hole (B). Remove axle/bearing assembly carefully to avoid seal damage.
NOTE: Seal removal from right side of differential housing requires differential disassembly. (See Disassemble Differential in this group.)
3. Remove seal (C), if necessary.
4. Install seal 2 mm (0.079 in.) below ball bearing shoulder. Flat side of seal faces out.
5. Install axle/bearing assembly until bearing bottoms in housing.
6. Install snap ring.

23. June 2021 by samuel07042012
Categories: F510-F525 | Leave a comment

Leave a Reply

Required fields are marked *